KA1J asked if he could use his K3 and his computer sound card to run CW
SKimmer, and you're telling him how he can spend between $500 (SDR-IQ)
and $1000 (QS1-R) for a solution that doesn't even actually use the K3.
That's like me asking if I can add a tailgate lift to my pickup and you
telling me to buy a forklift.
Dave AB7E
On 11/28/2012 9:40 AM, Greg wrote:
Another option is to use something like an active rx antenna on the
SDRIQ with a relay to disconnect during transmit. I did this with the
QS1R for awhile and it was a good combination.
On 11/28/12, Greg <[email protected]> wrote:
Yup.....Works fine too.
On 11/28/12, KQ8M <[email protected]> wrote:
Your just sharing the RX antenna now not actually using the K3's IF.
73,
Tim Herrick, KQ8M
Charter Member North Coast Contesters
[email protected]
On 11/28/2012 10:19 AM, Greg wrote:
I must be crazy but I had an SDR-IQ connected to the RX OUT and used
the rig control in the software connected to a VCP with LP Bridge and
it worked fine.
On 11/28/12, KQ8M <[email protected]> wrote:
Unfortunately no, it only decodes +/- 12kHz. In the setup you use
SDR-IF
not
SDR-IQ so you can control the radio. The software is
limited to +/- 12. The author cannot/will not expand that.
73,
Tim Herrick, KQ8M
Charter Member North Coast Contesters
[email protected]
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Greg
Sent: Wednesday, November 28, 2012 12:38 AM
To: David Gilbert
Cc: [email protected]
Subject: Re: [Elecraft] CW Skimmer & K3
If you use an sdr-iq with the K3 CWS will decode up to 190 kHz I
believe.
Greg
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
