typo correction should say Tony Parks *KB9YIG* not Tony Parks KB9RG.
On 11/28/2012 5:31 AM, Sam Morgan wrote:
check out the SoftRock Lite II SDR receiver from Tony Parks KB9RG. You can use his 8.215 MHz SoftRock Lite II for K3 IF application that comes with the xtal for the K3'a IF. Then tap the K3's IF through a buffer amp and bandpass filter from Clifton Laboratories. Run that output into a sound card capable of at least 48khz and you have your feed for the CW Skimmer software. Links to more info: http://wb5rvz.com/sdr/ WB5RVZ's Documentation site about all Tony's SDR's http://wb5rvz.com/sdr/sr_lite_ii/ SoftRock Lite II docs http://fivedash.com/ Tony KB9YIG's site http://cliftonlaboratories.com/ Clifton Labs site http://www.cliftonlaboratories.com/z10010_bandpass_filter.htm Bandpass filter http://cliftonlaboratories.com/z10000_buffer_amp.htm Z10000 Buffer Amp http://www.telepostinc.com/soundcards.html sound card recommendations get out your soldering iron Gary, this can be done the old fashioned way for way less than $500 bucks.... did I mention it's also fun? <g> P.S. if you spring for a better sound card (96khz or 192khz) you might get a kick out of the NaP3 software. Using LP-Bridge you can even use them all at the same time off the one K3 Serial Port. http://www.telepostinc.com/NaP3.html
-- GB & 73 K5OAI Sam Morgan ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
