Ian, Does the rig voltage sage when transmitting?
73, Bill K9YEQ -----Original Message----- From: elecraft-boun...@mailman.qth.net [mailto:elecraft-boun...@mailman.qth.net] On Behalf Of Ian Kahn - Ham Sent: Saturday, December 22, 2012 7:51 PM To: elecraft@mailman.qth.net Subject: Re: [Elecraft] New Output Power Issue Ron, With all due respect, this 40-watt power loss is noted in a watt meter connected directly to the ANT1 output on my K3, and then directly to a 300-watt dummy load. There is nothing else in between to cause a power drop. Where else would you recommend I look for the source of my problem, if not in the transceiver itself? 40 watts may only be about 1/3 of an S-unit, but that isn't the point. The point is that my rig is not performing as it should. I would like to fix the issue, in the most cost- and time-effective manner possible. If there are tests I can run to help isolate the problem, I'm open to suggestions. Thank you. --Ian Ian Kahn, KM4IK Roswell, GA EM74ua km4ik....@gmail.com K3 #281, P3 #688 HRD v5.x/6.0 Test Team On 12/22/2012 6:13 PM, Ron D'Eau Claire wrote: > And you'll likely find the cause of your "low signal strength" is > somewhere else, since 60 watts is only 2 dB - about 1/3 of an S-unit - > below 100 watts. > > That difference is not usually detectable on HF given normal > variations in propagation that go on constantly. > > 73 Ron AC7AC > > -----Original Message----- > > > Have you run "Calibrate Transmitter Gain" using the K3 Utility from > Elecraft? Just follow the instructions carefully and it's very simple > and fast. There are two levels to run, 5 and 50 watts if I remember correctly. > You will get a report at the end and can watch the progress on you K3 > display. > > > > God Bless & 73! > Jack - WE5ST > > > ________________________________ > From: Ian Kahn <km4ik....@gmail.com> > To: elecraft@mailman.qth.net > Sent: Saturday, December 22, 2012 3:25 PM > Subject: [Elecraft] New Output Power Issue > > All, > > Lately I've been receiving sporadic reports of low signal strength on > my K3, s/n 288. So, today I put a meter on it and ran an FSK signal > at 100 watts into a dummy load. To my amazing surprise, the meter > only read about > 60 watts out. I just upgraded last night to the latest firmware > version (MCU 4.60, FPF 1.15, DSP 2.80), What should I begin looking > at or adjusting to find the source of this issue? Any and all > assistance is greatly appreciated. > > Thanks, 73, and Merry Christmas. > > -- Ian > Ian Kahn, KM4IK > Roswell, GA EM74ua > km4ik....@gmail.com > K3 #281, P3 #688 > HRD v5.x/6.0 Test Team > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net Please help support this email > list: http://www.qsl.net/donate.html > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net Please help support this email > list: http://www.qsl.net/donate.html > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net Please help support this email > list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html