Don't change anything - leave it alone.
Dick - W7QHE Owner KX1, K2, K3, KPA500, KAT500, etc. ============================= Message: 5 Date: Thu, 27 Dec 2012 10:00:40 -0800 From: Jack Brindle <[email protected]> To: [email protected] Cc: [email protected] Subject: Re: [Elecraft] KPA500 PWR Display Message-ID: <[email protected]> Content-Type: text/plain; CHARSET=US-ASCII Tapping a button on the KPA500 causes the parameter associated with that button to be displayed. Try tapping the HV button, you will see the voltage displayed on the LCD. Tap HV again and you get the previous parameter displayed. Thus tapping a band button causes the band to be displayed. To illustrate why this is important, try the following: tap the HV button. The HV will be displayed. Next tap the CURRENT button. The LCD will change to current. Now tap the Current button again. The LCD will change to HV, not to the band. At this point the only way to get to the band is to tap a band button. Thus this is actually the correct behavior. How would you have it behave differently? In other words, what would you change to get the behavior you would like? Note that when changing the band from the transceiver the LCD will momentarily display the new band, then will go back to whatever parameter you have selected. Jack Brindle, W6FB ============================= ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
