K9SD already makes this device...
Dr. William J. Schmidt - K9HZ / J68HZ/ 8P6HK/ ZF2HZ Owner - Operator Big Signal Ranch Staunton, Illinois email: [email protected] -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Bill Clarke Sent: Saturday, January 05, 2013 8:54 PM To: [email protected] Subject: [Elecraft] K3 Remote VFO tuning control I would like to see a remote tuning device (VFO control only) that can be moved around the desk etc. It needs to be simple - such as an extra VFO encoder mounted in a box and on a wire in parallel to the existing VFO-B encoder. Elegant by simplicity - it could plug into a jack installed on the bottom edge of the front panel (or simply a 5-conductor line brought out from VFO-B). I may be wrong, but I sure don't look at this as rocket science - it is all mechanical and a little soldering. It would only be active when VFO-B is selected. Any comments? Thanks, Bill W2BLC ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
