Just a note to say that I recall the monitor delay is adjustable in the Config menu.
Rich, n0ce ----- Original Message ----- From: Wright, Robert To: e...@elecraft.com Cc: elecraft@mailman.qth.net Sent: Thursday, February 21, 2013 11:35 AM Subject: Re: [Elecraft] [K3] VOX on the K3 - Smooth Voice Controller Eric, Interesting and neat. I should have expected you were already on top of this. :-) I just went back to the K3 and played with it a bit. Just by listening, the monitor delay seems to be the same whether I have VOX enabled or not. This is just the normal acceptable delay I have come to expect in the K3's monitor. The Smooth Voice Controller had a nominal 85mSec delay (QST article April 1992 pg. 42) and, if I recall correctly, seemed much more noticeable than what I am hearing in the K3. Eric, can you comment on the amount of delay used for the K3 VOXing? (Saves me setting up for a measurement.) Does the monitor come before that delay? Am I hearing, in the monitor, what is being transmitted (relative to the PTT-voice timing and first syllable cut-off)? Thanks, Bob N7ZO -----Original Message----- From: Eric Swartz - WA6HHQ, Elecraft [mailto:e...@elecraft.com] Sent: Thursday, February 21, 2013 8:49 AM To: Wright, Robert Cc: elecraft@mailman.qth.net Subject: Re: [Elecraft] [K3] VOX on the K3 - Smooth Voice Controller This is -exactly- what we do in the DSP for the K3's VOX to eliminate any cutting off of the first syllable. You can talk normally without that 'Ahh' at the beginning of sentences to avoid loss of info ;-) 73, Eric elecraft.com On 2/21/2013 8:07 AM, Wright, Robert wrote: > I used to have a box from A&A Engineering called a Smooth Voice Controller. It was a VOXer with a short audio delay line (bucket brigade IC) to allow the PTT to get to the radio before your first syllable. The result was no clipping at the beginning of each phrase. The only downside was that monitoring yourself with headphones was tricky with the delay. But the VOX results were very good. > > I've always thought that this concept would be a great improvement to the K3's VOX and could be done readily in the DSP. It could be a menu setting with the voice delay variable from 0 (normal operation) to some fixed amount. It would only need to be enabled when VOX was on. > > 73, Bob N7ZO > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html