Hi Dana, As I understand it, the IQ output from the KX3 is before the "roofing filter and DSP. Thus any bandwidth settings you have on the KX3 should not have any effect on the IQ output. You did not mention what particular program you are using on your computer. If you are exchanging data between the KX3 and that program, I would suggest you disconnect the cable that allows that and see what happens. It could be that the issue lies in the program and not the KX3. 73 - Mike WA8BXN -------Original Message------- From: Dana Browne AD5VC Date: 3/4/2013 10:46:52 PM To: Elecraft Mailing List Subject: [Elecraft] KX3 PBT on SSB I have been using my KX3 with digital software and seem to have some odd behavior using the PBT. I have it set to do upper cutoff/lower cutoff on USB or LSB and am watching the received display on the waterfall. As expected, the upper cutoff in the noise follows the cutoff displayed on the screen, up to a point. However, if I lower the cutoff below 2.35 kHz, there is an additional dead zone (no noise on the display) from 1.4 kHz to 1.6 kHz. The same thing happens on LSU at 2.45 kHz. This appears no matter what band I am on, so I assume it is something in the DSP software. No such dead zone appears if I raise the lower cutoff. I am using MCU 1.36 and DSP 1.05. Has anyone else observed this? Dana Browne AD5VC ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected]
This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
