KX3 beta firmware rev 1.44 (with DSP rev 1.16) is now available. See release
notes below.
You'll need the KX3 Utility application to download and install firmware. For
full instructions on loading beta releases, refer to our KX3 software page:
http://www.elecraft.com/KX3/KX3_software.htm
Wayne
N6KR
* * *
MCU 1.44 / DSP 1.16, 4-24-2013
* NOISE REDUCTION (NR) EASILY ADJUSTABLE: The overall level of noise reduction
can now be set using the knob above the NR switch (AF/RF-SQL). When NR is
turned on, the present setting will be displayed on VFO B for about 2 seconds.
To select a new setting, rotate the knob before the display times out. The
setting is independent for CW and voice modes. Note: The range of this
parameter is 0-10, corresponding to the “mix” or “M” parameter of the RX NR
menu entry. See below.
* RX NR MENU ENTRY CHANGES: The RX NR menu entry can be used to adjust all
three NR parameters (B=beta, D=decay, M=wet/dry mix). The M parameter now has a
range of 0-10, matching the range available when the knob above the NR switch
is used (see above). As before, all parameters can be adjusted separately for
CW and voice modes. In most cases the factory default settings can be used for
beta and decay, and the mix adjusted for the desired overall amount of NR using
the knob (without using the menu). You can also now reset all NR parameters to
factory defaults by holding CLR.
* DVR PLAY/REPEAT FIX: DVR play no longer drops messages.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
