I'm just finishing my KAT100 build to use with K2/100 SN #7230. I did not build the K2 and have never built one - so unfamiliar territory.
The instructions say to pull the control board and KAF2 if present. It also says to use the "long handled Allen wrench" - yea I don't have that . This K2 has a KDSP2 installed. I need to cut the trace and install R12 between R8 and R9. I popped the top panel between the front panel and the KPA100 and can see the board and the resistors. This K2 has a jumper placed where the R12 needs to go. Before I start pulling stuff apart can someone give me a bit of a clue how to pull this board? I don't want to break an excellent working radio. If Don is reading this - it's the one you fixed for me. I don't want to have to send it to you again. "Dammit Jim I'm just an old country doctor!" Thanks for any help you can be. 73 Stan AE7UT -- View this message in context: http://elecraft.365791.n2.nabble.com/KAT100-project-removing-the-control-board-tp7573412.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
