Stan, The "Allen wrench" that was supplied in the K2 kit is an ordinary allen wrench, nothing special. Without hunting mine up it is maybe a 1/16 or 1/8, right-angle that is a couple of inches long. Elecraft just wants you to use this as a pry-tool. If you do not have a standard set of allen wrenches, you could maybe borrow one or buy a cheap set somewhere.
Check the K2 build manual for wrench description in the inventory, anything close will do, and instructions on how to perform this "prying" correctly as this is necessary between a partial build test and completion of the original K2. Basically you need to lift the control panel so you put the bend of the wrench on a mount screw head and use the short ned of the wrench to push the board up at a location that does not have any nearby traces to be damaged. I know that you are working with a K2 that you did not originally build and the step you are describing may not be necessary, but you should probably become familiar with this process any way. You will not break anything looking at the documents so at least do that and see how "not to scary" the process is. good luck & 73, Fran On May 5, 2013, at 2:57 AM, Stan AE7UT <[email protected]> wrote: > I'm just finishing my KAT100 build to use with K2/100 SN #7230. > I did not build the K2 and have never built one - so unfamiliar territory. > > The instructions say to pull the control board and KAF2 if present. > It also says to use the "long handled Allen wrench" - yea I don't have > that . This K2 has a KDSP2 installed. I need to cut the trace and install > R12 between R8 and R9. > > I popped the top panel between the front panel and the KPA100 and can > see the board and the resistors. This K2 has a jumper placed where the > R12 needs to go. Before I start pulling stuff apart can someone give me > a bit of a clue how to pull this board? I don't want to break an excellent > working radio. If Don is reading this - it's the one you fixed for me. > I don't want to have to send it to you again. > > "Dammit Jim I'm just an old country doctor!" > > Thanks for any help you can be. > > 73 > Stan AE7UT > > > > > -- > View this message in context: > http://elecraft.365791.n2.nabble.com/KAT100-project-removing-the-control-board-tp7573412.html > Sent from the Elecraft mailing list archive at Nabble.com. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
