Hi Jean,
Measured at 37mm for a knob from a vintage 2000 K2 #1400. So, two
measured at 37mm and one suggestion of 1.6 inches (40.64mm). Any
advance, going once, twice......
A popular replacement in the early years was the knob from a Yaesu
FT100. Nice rubber ring on it and a not too useful finger dimple. So
many FT100 knobs ordered that apparently Yaesu thought there was a
quality control problem.
Regards,
Mike VP8NO
On 10/05/2013 10:10, Behiels JeanPierre wrote:
Hi Elecraft members
Is there any K2 builder witch could give me the exact diameter(mm or inches)
value of the standard delivered VFO dial knob of the K2 rig ,I like to now.
Regards Jean ON4AEF.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
