You could simply run your coax from the relay after the amplifier directly to the rx-in
jack. Surely an internal preamp would be located between this jack and the rest of the
receiver. You just wouldn't need to use the rx-out jack.
Am I am missing something here?
On 5/26/2013 11:23 PM, Edward R Cole wrote:
I am amazed at the length of conversation on this topic. IN fact an internal 6m preamp
would be counterproductive to my needs. I will be adding a 1100w solid state 6m
amplifier and would have to add two coax relays to bypass it in receive if the preamp
were internal. Connecting the 6m preamp in the existing configuration I run the antenna
input to a single 1200w rated coax relay at the output of the transmit power amp:
http://www.kl7uw.com/6M-EME-LAYOUT.jpg
Here is how my non-Elecraft preamp is installed on my K3/10:
http://www.kl7uw.com/K3-ARR-6mPreamp.jpg
my six meter webpage:
http://www.kl7uw.com/6m.htm
73, Ed - KL7UW
--
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco/
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html