You are assuming the internal K3 preamp is adequate on 6m in the
K3. The reason for the PR6 is that the internal preamp is not
adequate for very weak signals (I intend to do 6m eme and ms). Of
course if you mean the PR6 is installed internal to the K3 then I
suppose it would work.
The current configuration is "bolt on" ready and no need for an
internal installation of the PR6 (or my preamp).
73, Ed - KL7UW
------------------------------------------------------
Date: Mon, 27 May 2013 09:01:37 -0700
From: Vic K2VCO <[email protected]>
To: [email protected]
Subject: Re: [Elecraft] Combo pre-amp
Message-ID: <[email protected]>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed
You could simply run your coax from the relay after the amplifier
directly to the rx-in
jack. Surely an internal preamp would be located between this jack
and the rest of the
receiver. You just wouldn't need to use the rx-out jack.
Am I am missing something here?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
