Make sure you're connected properly with Line In and Out. Set the MIC SEL to the correct input (Line In) while in TX DATA mode.
73, matt W6NIA On Sun, 09 Jun 2013 08:46:09 -0700 (PDT), you wrote: >Hi, > >Mr K3 has arrived!!! So far everything has gone well, except one thing. I am >using a SignaLink USB, as I had one and used it on my formeer radio. I have the new cord and jumper wire card installed. It is connected to the wire in, wire out, and PTT on the radio and into the SL, thence into the computer. I have changed Hamlib to K3 in the configure box. I received just fine, but when I try to send it lights up the PTT light in the Sl and the TX light on the K3, but no signal. The K3 mode is set on USB, but the same result on Data> I know that I am doing something wrong. Helpl! > >Dick, N5XRD > >______________________________________________________________ >Elecraft mailing list >Home: http://mailman.qth.net/mailman/listinfo/elecraft >Help: http://mailman.qth.net/mmfaq.htm >Post: mailto:[email protected] > >This list hosted by: http://www.qsl.net >Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
