Jim,
Have you tried re-dressing the ribbon cable routing inside the P3? That
is an important item. Check the P3 assembly manual to make certain the
cables are routed in the proper manner.
73,
Don W3FPR
On 12/6/2013 1:57 PM, Jim wrote:
Any guidance on the artifacts I am seeing with the P3?
I have the problem that has been discussed in detail. When I tune to certain
frequencies, I will get a "blip" on the screen that is 5-6 dB above the noise
and I have the classic artifact that is ~3 kHz wide and 4-5 dB above the noise floor,
that is just below the tuned frequency. I have the ribbon cable dressed to the LHS of
the chassis and the coax on the RHS (when looking at the P3 display).
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
