Hello All
I'm on Page 28 of the manual. D1 lights and the LED is OK. However
when I start to do voltage checks, I get results that are nothing
close to the manual. Now granted, I'm using a Radio Shack DMM (!)
which is flaky and inconsistent, but when I get good contacts it
shows that the supply voltage at both ends of D2 is OK. The other
readings on D2 and U1 bear no relationship to normal. For example on
U1 pin 1 I get no voltage.
Could be the DMM of course, (I've sent away for a Fluke), or my lack
of expertise, but I'm stopping until I get this resolved.
Should I be taking these readings from the top or bottom of the PCB -
I've tried both ways. By the way, which is pin 6 on U3?
All solder connections look good.
TIA,
Jeff KG6ZVT
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
