Reading the P3 screen I see a station transmitting. I use Marker A (Green) to pin me on that desired station as soon as I tap the knob to QSY me to a desired signal.
I listen to the station and they say UP so I know to hold in the MKR button to activate B ((Magenta) I see where the last transmission is and I place the Magenta marker at that location and tap: The Sub Rx goes to that frequency where the DX was last listening but sub is not engaged, it just sits on that frequency and does nothing with it. Problem is that if I don't then reach over and manually hold the split button on the K3 itself to have the K3 transmit on the DX listening frequency, I'll still keep transmitting on the DX transmit frequency because the K3 will not have gone split; its as if the procedure is halted half way and it shouldn't function this way, its not intuitive. If I'm going to the effort to engage Marker B to QSY its because I want to transmit on the Marker B frequency. What do I have to the do differently to force the K3 go split to transmit on the B freq when I tap on MKR B? Thanks, Gary KA1J --- This email is free from viruses and malware because avast! Antivirus protection is active. http://www.avast.com ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
