Phil,
Look at the cable shown in the KAT100 manual page 25.
Note that the cable connects to the AUX I/O connector.
That is *not* a serial port - only three pins are RS-232, RXD, TXD and
Signal Ground.
Do not plug a serial cable directly into the K2, it can damage the K2 or
the serial port or both. You must use the special cable to connect to
the computer or a serial adapter.
73,
Don W3FPR
On 3/24/2014 3:26 PM, Phil Wheeler wrote:
But with a K2/100 connected to a KAT100 it seems there is no serial
port left over for computer control of anything (can't pull mine out
now to look due to a project underway on my desk, but that's my
recollection).
So is there a way to use a computer with this trio of K2 elements?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
