Hi Steve, I have KRC2 which works without issue with my remote TS-480.
I had conversation with Gary from Elecraft some time ago and his setup proposal works OK for me. Jumper settings inside KRC2: ------------------------------------------- Jumpers IN: 3, 6, 9, 10, and 21-23 Jumpers 14 & 17 bridged with voltage from pin 7 of U2 fed to this jumper (~2" piece of wire). Jumpers W7 and W8 depend of data rate, see KRC2 manual page 20 Hope it helps 73 Robert, S57AW 2014-04-08 12:52 GMT+02:00 Steve Bunting <[email protected]>: > Hi everyone, > > > I have KRC2 band decoder that I used ages ago with my K2 - it still works > in that I can toggle bands when I hold the F1 button. I want to use it with > my remote TS-480 but the radio CAT isn't currently driving KRC2 at all and > I would like some advice on how to get it working, please. > > > Current set up: I have used the Kenwood jumper positions from the KRC2 > manual and have a straight through serial cable from rig to KRC2. I am > using 4800 baud (W7 and W8 in place) and the radio CAT works with my PC. > The KRC2 is certainly in operate mode and I have a 13.8V PSU attached > (stating the obvious!) > > > Questions: I suspect I need to apply the handshake jumper between W14 and > W17 for the TS-480? Does the position of W7 and W8 matter for 4800 baud? > I'm assuming the manual is correct. Can any 480/KRC2 users comment on > anything else I have missed? > > > > 73 > > Steve > > M0BPQ > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
