Steve,
You will have to refer to your TS-4800 documentation to determine the
data rate (setting for W7 and W8 jumpers) and the proper setting for the
handshake jumpers W14 and W17.
I do not have a TS-4800, but the manual should tell you what is needed
and then the KRC2 manual will tell you how to plug it.
73,
Don W3FPR
On 4/8/2014 6:52 AM, Steve Bunting wrote:
Hi everyone,
I have KRC2 band decoder that I used ages ago with my K2 - it still works
in that I can toggle bands when I hold the F1 button. I want to use it with
my remote TS-480 but the radio CAT isn't currently driving KRC2 at all and
I would like some advice on how to get it working, please.
Current set up: I have used the Kenwood jumper positions from the KRC2
manual and have a straight through serial cable from rig to KRC2. I am
using 4800 baud (W7 and W8 in place) and the radio CAT works with my PC.
The KRC2 is certainly in operate mode and I have a 13.8V PSU attached
(stating the obvious!)
Questions: I suspect I need to apply the handshake jumper between W14 and
W17 for the TS-480? Does the position of W7 and W8 matter for 4800 baud?
I'm assuming the manual is correct. Can any 480/KRC2 users comment on
anything else I have missed?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
