Consider disconnecting the RS-232 connection and leaving the
audio connection. Then use VOX to key the transmitter. If that
leaves the mode unchanged, then something from HamLib is
changing the settings on the KX3.
Cheers - Bill, AE6JV
On 4/22/14 at 6:28 PM, [email protected] (Don Wilhelm) wrote:
You might want to try using RigCAT instead of HamLib - choose K3 if KX3 is not
available.
The only function necessary is PTT keying and the proper display of frequency
on the waterfall.
73,
Don W3FPR
On 4/22/2014 8:50 PM, Adrien Dessemond wrote:
Don,
My error I apologize, "AUDIO A" should be read as "DATA A" in my
original post. My concern was the transmission mode used by the KX3
once FLDIG triggered a data transmission as it does not seem to stay
in "DATA A" mode anymore, I will dig inside the Hamlib ... :-) Thank
you your answers.
---------------------------------------------------------------------------
Bill Frantz |"After all, if the conventional wisdom was
working, the
408-356-8506 | rate of systems being compromised would be
going down,
www.pwpconsult.com | wouldn't it?" -- Marcus Ranum
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
