I am a first time "K1" builder and am having a very difficult time getting the
proper voltage measurements for the test on page 46 of the manual.
Test point J7 pin 8 should be 3.8vdc I get "0"
The test points on Diodes "D9","D10","D11","D13", all measure "0"
Any suggestions as to how to go about troubleshooting these problems? I have
had no problems up to this point, but this has me stumped.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
