I believe you will find it under CW Weight in the manual
here is the snipit from the manual
CW WGHT 1.15 Adjusts element/space timing ratio (weight) for the
internal keyer.
Additional functions of this menu entry, via numeric keypad (Advanced):
Tap 1 to select SSB -CW (default) or SSB +CW (allows CW in SSB modes).
Tap 2 to select @ = STOP (‘@’ character terminates KY-packet transmission;
default) or @ = ‘AC’ (‘@’ in a KY packet is sent as .--.-. [@] in CW mode).
Tap 3 to select OLD or NEW QSK (default). NEW reduces AF keying artifacts.
Tap 4 to select VOX NOR (default) or AUTO OFF. The AUTO OFF setting
turns CW VOX off on power-up, avoiding accidental keying by attached
PCs, etc.
Tap 5 to select automatic VFO offset on SSB/CW mode change (VFO OFS) or
no offset (VFO NOR, default). Automatic offset is often used on 6
meters, where
mixed-mode QSOs are necessary during fading. Note: Pitch matching will be
more accurate if USB is paired with CW REV, and LSB with CW normal.
I think it is the Tap 5 part
sm
On 5/15/2014 11:12 AM, Edward R Cole wrote:
I give up...didn't find any "Autoshift" in the menus of either the K3 or
KX3. Is this about some other radio? Or is a feature of some early vs
of firmware long gone? I'll admit not updating the K3 lately (vs 4.81).
In doing frequency drift measurements I noted that Frequency seen in USB
mode is different than what is seen in CW mode. The shift appears to be
that of the sidetone frequency which I have set to 550-Hz for performing
the temperature compensation procedure on the KX3.
To hear the test signal in USB I have to retune the VFO if I switch from
CW. I have a good ear for tone frequency so am able to tune in the test
signal in USB to match the CW sidetone frequency. That requires moving
the dial about 550 Hz. If on the wrong sideband you will *not* hear it.
73, Ed - KL7UW
---------------------
From: Oliver Dr?se <[email protected]>
To: [email protected]
Subject: Re: [Elecraft] CW on SSB
Message-ID: <[email protected]>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed
And enable auto-shift in the menu when switching from CW to SSB and vice
versa, otherwise you will still have to retune to get signal into the
passband again.
73, Olli
Contest, DX & radio projects: http://www.dh8bqa.de
73, Ed - KL7UW
http://www.kl7uw.com
"Kits made by KL7UW"
Dubus Mag business:
[email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
--
GB & 73
K5OAI
Sam Morgan
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
