Bob, In addition, you will need to do a re-alignment of the filters/BFOs after you change the crystals, and while you are doing that, it is only a few steps to do a complete calibration. For the full information on how to accomplish that, take a look at my website http://w3fpr.qrpradio.com article on K2 dial calibration - Step 3 of that article goes into the CAL PLL procedures with references and links provided.
The procedure is not difficult, but does require some care in executing it to assure good results and optimum performance from your K2. You will be pleased with the crystal change - not only on SSB, but for CW as well. 73, Don W3FPR > -----Original Message----- > > I've ordered the 2nd stage mod kit. I'm also going to do the matched > crystal mod on general principles. Thanks for the help, I may buy a > microphone for it some day. I added the SSB for digital modes a few > years ago but never checked SSB audio. > > Bob Baxter AA7EQ > Walnut Ridge, Ar. > > On 12/10/05, Ron D'Eau Claire <[EMAIL PROTECTED]> wrote: > > > It's just one mod, Bob. Look up the Elecraft web site "Builders > Resources". > > Under "Mods:" you'll find, "K2 2nd Stage Xfil Mod, for > 'Flatter' SSB Filter > > Response". > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
