A way to simultaneously interface a paddle and computer to the KX3 --
The KX3 has two paddle inputs - one in the front for the KXPD3 and the
other on the left end.
They can independently be set to either Hand or Paddles. Yes, if you
want to use the front one with anything other than the KXPD3, you will
have to create an adapter. Several suggestions on how to accomplish
that can be found in the archives.
So you can end up with one input for the computer generated code and
another for paddles.
73,
Don W3FPR
On 5/22/2014 4:29 PM, Jim Brown wrote:
On 5/22/2014 12:51 PM, Pete Smith N4ZR wrote:
I understand that the KX3 does not have the K-3's built in CW and PTT
interfaces on the RS-232 port, but it is really trivial to take off
the DTR and RTS lines from the RS-232 cable and through a couple of
one-transistor, one-resistor interfaces to the appropriate ports
Yes, I've built several of them. The tricky part, though, is
simultaneously interfacing a paddle to send fills.
73, Jim K9YC
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
