Hi Mike, Does the KPA500 follow the band switching and display the correct band on its LCD? That would mean that the band data is getting through the cables. The KAT500 uses the AUXBUX (pin 2 in the 15-pin cable) to get the frequency information in addition to the band data pins. You might check your K3-KAT cable to see if that pin is OK.
You might try going through all the KAT500 configuration screens to see if something looks amiss and then open the Operate screen. (In the KAT500 Utility). That screen is VERY useful to help you figure out what is going on. 73, Fred KE7X "The Elecraft K3: Design, Configuration and Operation 2nd ed" "The Elecraft KX3 - Going for the summit" "The Elecraft KPA500 and KAT500 - the K-Line Dream Station" All available at www.elecraft.com KPA500 and KAT500 Quick Set Up Guide http://www.ke7x.com/home/k-line-introduction-and-set-up-guide > -----Original Message----- > From: Elecraft [mailto:[email protected]] On Behalf Of > Fred Jensen > Sent: Saturday, June 14, 2014 2:57 PM > To: [email protected] > Subject: Re: [Elecraft] KAT500 operation? > > On 6/14/2014 12:11 PM, Mike Hagele AC6JA via Elecraft wrote: > > I am using a K3 and KPA500 with the KAT500. I also have the KAT500 > > mode set to MAN. I thought that the firmware was supposed to switch > > the tuner automatically when you switch bands? After I go to a new > > band, I need to tap my key momentarily to get the tuner to tune to > > the new frequency. Is this normal? Let me know as I thought the > tuner > > would remember the presets when QSY'ing to a new frequency? > > Any help would be appreciated. Thanks. > > Hmmm ... I have the control cables ... K3-->KAT500/KAT500-->KPA500, > I've trained my KAT500 for all 3 antennas on all the bands that each of > them work on, and I run the KAT500 in MAN. All indications are that > the > KAT500 recalls the correct solution for the frequency when I QSY to a > new frequency or band. > > I'm hardly an expert on the insides of Elecraft firmware, and I suppose > it could be recalling on very first sign of RF and doing so very > quickly so that I don't notice it, but I really don't think so. > > I do notice when changing bands that the K3 power control sometimes > takes a dit or two to settle to the correct drive power ... often that > first dit will blink the 600 [occasionally 700] watt LED. > > 73, > > Fred K6DGW > - Northern California Contest Club > - CU in the 2014 Cal QSO Party 4-5 Oct 2014 > - www.cqp.org > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
