I have pretty much done an thorough search on this topic and have
concluded it cannot be done, but I thought I would throw it out here anyway.
I believe that the outputs on the KRC2 on strictly controlled by band
information which it receives. I was wondering if there was a way to
send RX antenna status to the KRC2 which would close an output to send
12VDC to my active RX antenna and another to activate 12VDC to the
preamp for the RX ant when I chose.
My thought was along the lines of the DVK messages which can be
activated via the keyboard when using Writelog or other contest
programs. I was hoping to send a command via the keyboard to activate
the RX ant on the K3 and at the same time send the required 12vdc to the
RX antenna via an output on the KRC2 and the same for the preamp if I
want it on/off.
I hope this is clearer than mud.
Rich
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
