Rich,
If the RX antenna is the only thing you want to control with the KRC2,
the answer is easy - just use the KRC2 configurator application to
select the outputs for the bands you desire.
The High level outputs can provide the source of 12 volts (up to the
current limit of the drivers).
I am not sure what that has to do with the DVK messages - I do not see
how those can be related.
73,
Don W3FPR
On 7/6/2014 11:46 PM, Rich wrote:
I have pretty much done an thorough search on this topic and have
concluded it cannot be done, but I thought I would throw it out here
anyway.
I believe that the outputs on the KRC2 on strictly controlled by band
information which it receives. I was wondering if there was a way to
send RX antenna status to the KRC2 which would close an output to send
12VDC to my active RX antenna and another to activate 12VDC to the
preamp for the RX ant when I chose.
My thought was along the lines of the DVK messages which can be
activated via the keyboard when using Writelog or other contest
programs. I was hoping to send a command via the keyboard to activate
the RX ant on the K3 and at the same time send the required 12vdc to
the RX antenna via an output on the KRC2 and the same for the preamp
if I want it on/off.
I hope this is clearer than mud.
Rich
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
