You better make sure you have a reliable ALC connection in there somewhere
because you'll smoke the PW-1 if you hit it with a hundred watts. They
normally take about 35 -45 watts drive for full output.
Why not try driving the PW-1 directly with the KX3? I did and it works
fine. I don't get a KW out, but it's quite respectable power out with 12
watts drive.
73, Charlie k3ICH
----- Original Message -----
From: "George Rebong" <[email protected]>
To: <[email protected]>
Sent: Tuesday, July 29, 2014 3:25 PM
Subject: [Elecraft] KXPA-100 to ICOM PW-1 amplifier
I used the RCA from the KX-3 to KXPA-100 adapter cable to connect the PW-1.
I can not change transceiver selection on my PW-1 and the RX signal goes
deaf/attenuated. Is there a setting that I can change to make my KXPA-100
key my PW-1?
Sent from my iPad 3G
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
