Just to clarify... use of ALC with the PW-1 is not to adjust drive
power. That's a bad practice. You MUST use the ALC line because the amp
uses this as a primary means of protection. Without ALC, a fault
condition can damage the amp.
73,
Josh W6XU
On 7/29/2014 12:41 PM, Charlie T, K3ICH wrote:
You better make sure you have a reliable ALC connection in there
somewhere because you'll smoke the PW-1 if you hit it with a hundred
watts. They normally take about 35 -45 watts drive for full output.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
