Pete,
PowerSDR had offset values for DIG_L and DIG_U. They represented the MARK frequency (2125 for DIG_L and 2295 for DIG_U). Are those set correctly in your installation? Unlike most rigs - except for Yaesu - which do not allow the dial to show the true RTTY (RF MARK) frequency in AFSK, the K3 AFSK A shows the RF MARK for AFSK A (it shows RF SPACE for AFSK A REV). That means you may need to do some iteration with the NaP3 DIG_L/DIG_U CAT Offset and the internal PowerSDR DIG_L and DIG_U offsets. Unfortunately the developer of NaP3 folded his tent and disappeared so there is no longer any authoritative support. 73, ... Joe, W4TV On 2014-10-02 2:58 PM, Pete Smith N4ZR wrote:
I would like to be able to use my K3 with NaP3 through an LP-PAN, but when I click on a signal, instead of going where clicked it sends the VFO to a frequency approximately 2 KHz lower. I presume it may be going to the suppressed carrier frequency instead of the Mark frequency. Both NaP3 and the K3 are in AFSK A mode.
______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
