I recently checked and upgraded all of the Firmware with my KX3 (MCU = 2.27, & DSP = 1.3), KXPA (1.32) and PX3 (1.16) that was older.
I found that it lost communications from the KX3 to the KXPA100. Hence it results in turning PA Mode Off. Even when I go back into the Menu settings, turn PA Mode on again, It results in turning PA Mode back off again. Even though I had full communications between the KX3 and KXPA100, to resolve the problem, I had to going into the utility program for the PX3, making sure it was communication with my computer, which it was, then update the KX3 Menu PA Mode to on. I am not sure where the glitch is occurring. I have the standard cable set up as in the PX3 Manual and all data rates are set to 38400 baud. It seems to be related to the PX3. Is there a way to extend the time out for the KXPA100? Thanks, Irwin -- Irwin KD3TB ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
