This was fixed in KX3 MCU rev. 2.28. I'll send you the latest (2.33). 73, Wayne N6KR
On Jan 16, 2015, at 10:59 AM, Irwin Darack <[email protected]> wrote: > I recently checked and upgraded all of the Firmware with my KX3 (MCU = > 2.27, & DSP = 1.3), KXPA (1.32) and PX3 (1.16) that was older. > > I found that it lost communications from the KX3 to the KXPA100. Hence it > results in turning PA Mode Off. Even when I go back into the Menu settings, > turn PA Mode on again, It results in turning PA Mode back off again. > > Even though I had full communications between the KX3 and KXPA100, to > resolve the problem, I had to going into the utility program for the PX3, > making sure it was communication with my computer, which it was, then > update the KX3 Menu PA Mode to on. > > I am not sure where the glitch is occurring. I have the standard cable set > up as in the PX3 Manual and all data rates are set to 38400 baud. It seems > to be related to the PX3. > > Is there a way to extend the time out for the KXPA100? > > Thanks, Irwin > > -- > Irwin KD3TB > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
