Tony
LINK ties both VFO's to the mail freq dial en keeps them insync when you
turn the dial knob.
So both receivers keep working on the same freq.
What I often use i diversity listening so with two receivers and two
antennas on the samen freq.
Diversity puts the main RX audio on the left ear of the headset, and the
Sub on the right ear. That's the normal situation.
In my case, the F9-F12 buttons in N1MM contain commands to the K3 that
switch the audio to my liking (that can also be done in the Config, but
that takes too much time during QSO) This way I can switch listening
from diversity (listen both MainRX and SubRX at same time) to only main
RX (main RX audio on both ears) or only sub RX (Sub RX audio on both
ears) depending on where the signal is best.
The commands to do this are in the programmers manual of the K3. It's
really fun to control some beautiful K3 features from the keyboard like
this.
73
Arie PA3A
N2TK, Tony schreef op 15-2-2015 om 16:38:
Hi Arie,
I am not sure I understand what LINK does to help when both receivers are on
the same freq. What does F9-F12 below do to help?
Tnx
N2TK, Tony
.....
- F9 = listen A-B
- F10 = listen A-A
- F11 = listen B-B
- F12 contains the commands to copy VFO freq and mode from A to B and LINK
the VFO's.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
