Exactly!
On 8/23/2015 7:00 AM, Joe Subich, W4TV wrote:
On 8/23/2015 1:21 AM, Richard W. Solomon wrote:
Not to flog this horse any further, but I direct you to page 85 of
the K2
Manual where the DB-9 connector is labeled ..."RS-232 and AUX I/O"... .
Is it RS-232 or not ??? Is it mis-labeled ????
RS-232 defines voltage levels (a bi-polar system greater than +3V or
less than -3V). It *does not define a connector*. The K2 Manual is
*entirely consistent* in saying RS-232 and Aux I/O ... the CAT pins
(2,3 & 5) are RS-232 levels, the others associated with Aux I/O (ALC,
Aux Bus, RF, +12, and 8R) are not.
Perhaps the DB connector associated with the KIO2 could be more artfully
described as "Auxiliary I/O" or Auxiliary I/O including RS-232 control
but the "RS-232 and AUX I/O" label is technically accurate.
73,
... Joe, W4TV
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
--
R. Kevin Stover
AC0H
ARRL
FISTS #11993
SKCC #215
NAQCC #3441
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
