Hello all. Last week I received my K3S/100 (S/N 10270) kit, including KDVR3 recorder, KRX3A second receiver, and .5ppm TCXO. After getting the kit assembled per the assembly manual, I got to the checkout phase prior to installing the 100W amp, and second receiver. The unit powered on as it should, however I got no "ERR PLL" message on the display as it stated I probably would. When I got to the Synthesizer Check, I was able to get into "TECH MD" mode, and turned it "ON". However, I was not able to get to "SYN1" to display in the VFO B area. The bottom part of the display would start with what I assume was supposed to be the time (however it was in the area of 37:20:20??), then as I rotated the VFO B knob, it would step through what I assume was the date, then "0.00", "13.6V", "1.05A", "FP 28C", "PLL1 2.9" (ranging up to "PLL1 3.2"), "PLL2*0.0", "AFV 0", and finally "0.0 dBV". This is all I can get.
Of course, with this being a holiday, contacting Elecraft wouldn't work, so I thought I would throw this out here to see if anyone had any ideas as to what might be wrong with my unit. Thanks, and I hope everyone is having a great Labor Day (where applicable). 73, Ken, KJ9B ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
