Kyle,
I watched the video.
For the lack of waterfall, check the Low Cut on your KX3. I suspect it
is set to about 600 Hz - meaning that you are not getting audio response
out of the KX3 below that frequency.
For the problem of not going back into receive, it could be either the
SignaLink holding PTT active (the most likely) or a problem with the KX3
or the PTT cable.
After your next trial, unplug the PTT cable from the SignaLink and see
if the KX3 goes back to receive - if so, the SignaLink has a problem
with its PTT output.
I do not have details on the SignaLink cables for the KX3. Does the
SignaLink PTT signal come in on the MIC jack? or does it use the ACC2 GPIO?
If it uses the ACC2 GPIO, do you have the KX3 menu ACC2 GPIO parameter
set for PTT?
73,
Don W3FPR
On 10/15/2015 3:18 PM, Kyle Krieg wrote:
Don,
Thanks for the reply!
Your correct about the ALC. I didn't have my TX level set high enough
on my signalink modem. Once I turned that up, 4 bars, with the 5th
flashing was present, so I think I'm good with that item. Thanks!!!
Instead of typing an email for the remaining items, I just made a
video and put it up on youtube. It will show the KX3 TX red light
still being lit after fldigi is done sending along with the waterfall
issue I'm seeing with no filters applied. Maybe seeing this vs
reading will spark some solutions.
https://youtu.be/qfUnyQsrgzM
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
