The K3/K3S already does this! Set Config:VFO OFS to ON. Adjust rate with Config:VFO CRS. 73, Ian N8IK
-----Original Message----- From: Elecraft [mailto:[email protected]] On Behalf Of Peter Pauly Sent: Monday, November 16, 2015 20:14 To: Elecraft Reflector <[email protected]> Subject: [Elecraft] Feature request: OFS Knob as frequency fast up/dn One of the few things I miss from my Kenwood TS-590S is the Multi/CH knob that lets you change the VFO frequency up or down 5 KHz for each encoder transition. I used this all the time to go quickly to a frequency within a band. It was even usually faster than the manual keypad entry. I propose that through a firmware change, the OFS (RIT/XIT) knob be used for such a purpose when it it not being used for RIT/XIT (LEDs are off). It seems to do nothing at the moment when RIT/XIT is not active. What do you guys think? ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
