Peter,
I assume you are talking about the KX3.
It is already there - look at the VFO CRS description on the manual (see
page 40). Note that this is a per mode setting. No firmware change is
necessary.
The K3 (and K3S) has something similar but uses the RIT knob if CONFIG:
VFO OFS is set to ON and both RIT and XIT are OFF.
I use that regularly on both my K3 and KX3.
73,
Don W3FPR
On 11/16/2015 8:13 PM, Peter Pauly wrote:
One of the few things I miss from my Kenwood TS-590S is the Multi/CH knob
that lets you change the VFO frequency up or down 5 KHz for each encoder
transition. I used this all the time to go quickly to a frequency within a
band. It was even usually faster than the manual keypad entry.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
