Kurt,
Yes, move whatever you have currently connected to the K3 RS-232
connector to the P3 PC RS-232 connector.
That should work fine for all except for loading firmware. To load K3
(or P3) firmware, do *not* connect through the Microkeyer2, connect
directly to a PC serial port or USB to serial adapter.
See the cautions on the MicroHam website about attempting to load
firmware with the MicroHam gear in-line.
73,
Don W3FPR
On 11/20/2015 10:34 AM, Kurt Wiksten wrote:
I have just bought the P3-kit to work with my K3 S/N 23xx.
According to the P3 manual, the Male – Female DE-9 cable
should be connected between the XCVR connector and K3:s
rear panel RS232 connector.
My present setup for the K3 is with Microkeyer2 as I am
working a lot of contests using N1MM+ for logging and Logger32 for DX-ing.
The station computer is a HP Laptop, using one USB-port.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
