In addition to Don's comments, set the serial data rate to 38.400 bps
in the K3, microHAM USB Device Router and all your user applications.
The P3 sets the K3 to 38.400 when it is running and results will be
better if the P3 does not need to change data rate between the K3 and
computer applications.
73,
... Joe, W4TV
On 11/20/2015 10:48 AM, Don Wilhelm wrote:
Kurt,
Yes, move whatever you have currently connected to the K3 RS-232
connector to the P3 PC RS-232 connector.
That should work fine for all except for loading firmware. To load K3
(or P3) firmware, do *not* connect through the Microkeyer2, connect
directly to a PC serial port or USB to serial adapter.
See the cautions on the MicroHam website about attempting to load
firmware with the MicroHam gear in-line.
73,
Don W3FPR
On 11/20/2015 10:34 AM, Kurt Wiksten wrote:
I have just bought the P3-kit to work with my K3 S/N 23xx.
According to the P3 manual, the Male – Female DE-9 cable
should be connected between the XCVR connector and K3:s
rear panel RS232 connector.
My present setup for the K3 is with Microkeyer2 as I am
working a lot of contests using N1MM+ for logging and Logger32 for
DX-ing.
The station computer is a HP Laptop, using one USB-port.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
