I don't know if the K3 IF output is broad enough to support a 4 MHz
span (I suspect it is not).
No, it is limited to the bandwidth of the preselector filters at best.
Since the two meter transverter uses 28 MHz as an IF, that would be
roughly 28 - 30 MHz.
Front end (at 2 meters) RF splitting is not practical since the
transverter does not have an externally accessible RX Ant loop
(like RX Out/RX In on the KXV3/A/B).
73,
... Joe, W4TV
On 2/7/2016 1:50 PM, Don Wilhelm wrote:
Bert,
I don't know if the K3 IF output is broad enough to support a 4 MHz span
(I suspect it is not).
He would have to find an SDR receiver capable of supporting that 4 MHz
span and connect it to the K3 IF output.
I do know that SDR dongles are capable of 2 MHz span, but I have never
seen one that does a 4 MHz span.
Perhaps your young friend will have to develop something on his own.
73,
Don W3FPR
On 2/7/2016 1:33 PM, Bert Rollen wrote:
All,
I have a young friend who wishes to do the following -
(my summary, not his words)
- Panadapter (or SDR) with 4Mhz or more display (not just a few
hundred kHz)
- Capable of 144 MHz - 148 MHz
- Point & click control a rig (K3, KX-3, Flex-6700, rig w/
144 MHz
transverter etc.)
Essentially, he wants typical pan-adapter display and control, but
4000 kHz
wide (or more)
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
