I did not check the firmware release notes.
If that is the case, then the switch will have to be set to the RS-232
position and the RJ45 to RS-232 dongle used until the firmware is updated.
Be certain the switch is returned to its normal position afterwards.
Also be certain the RJ-45 plug is fully inserted. You will hear a
definite click when it is fully seated.
You may have to slide the boot cover back a bit to push the plug home.
73,
Don W3FPR
On 2/9/2016 9:16 AM, Tom Crayner wrote:
Don,
Wasn't the KIO3B code added at firmware level 5.x?
If so, not sure the K3 knows anything about the USB setting unless it is
polling those settings directly from the board itself.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
