Here is something to check:
Right-click the speaker icon in the Task Bar and select Recording
devices. In the Sound window select the USB Audio Codec and click on
Properties. In the Properties window click on the Advanced tab and check
the Default Format. If it is set to 1 channel, ... change it to 2
channel, ... .
Also, make sure that the USB Audio Codec is not selected as the Default
Device or the Default Communications Device - these should both be set
to the motherboard sound card in your PC.
You should see main RX audio in the left channel. If the subRX is off,
you might see a bit of leakage from the left channel in the right
channel, but if the subRX is on you should only see subRX audio. When
you are transmitting, if your Monitor level is non-zero you should see
the transmitted signal in both channels.
73,
Rich VE3KI
N2TK wrote:
Trying to setup the CODEC on the KIO3B. Is it stereo that it will allow me
to do what I am presently doing for two channels?
When I select Microphone (4-USB Audio CODEC) for both MMTTY's, I get the
same signal on both MMTTY's. The second receiver has no impact.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
