Manuel, If you can receive a signal with an antenna connected to C225, but not C226, or 227, your most likely problem is improperly tinned toroid leads on L25 - but check L26 while you are working in that area.
A quick check is to make a continuity check from the top end of C225 to the top end of C227 - if you measure much more than zero ohms, the toroids are not properly tinned and soldered. 73, Don W3FPR > -----Original Message----- > > I tried N0SS's probe and I pick up a strong signal through all > test points > up to C225. I have no signal pick up there nor at C226 or C227. I did not > check W6 and W1 because I did not install those jumpers (I followed the > Rework Eliminators instructions that call for other steps). I do > not know if > there is an alternative test point for those. I have been through > the usual > checks for bad solders etc. > > I have used the proper solder and a controlled temp soldering station. > > I would very much appreciate your assistance and guidance. I have > had the K2 > on for hours now (playing with the keyer) and there has been no > change. It > looks great, that is for sure! > > Thank you very much > 73 > > Manuel > LU5OM > CT4IK > K2 # 5310 > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
