Manuel, No need to re-do the alignment. Later, you will re-peak L1 and L2 in the transmit mode as a final step which provides a more defined peak than one can hear in receive. A signal generator will not be required. If you tuned L34 with the weak 7000 kHz birdie as instructed in the manual, that is correct, no re-do is necessary.
73, Don W3FPR > -----Original Message----- > > I had my 160 plug-in Rework Eliminator plugged-in backwards... > ... > Because of the header's position shall I do the whole > calibration/alignment > step-by-step (page 60 to page 64) procedure of PART II all over > again? I am > also concerned about final adjustments of L34 and L1+L2 as I have > to rely on > regular noise to do that. No signal generator here. The 7000 khz weak > internally-generated signal is there. > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
