Are you on the latest firmware rev level in the 2M module? I thought I was and missed an update somewhere along the way.
I recently pulled my 2M module and sent it to Elecraft because one of the two crystals was marginal, and it was dead from 146-148 MHz. I got back their evaluation and, along with the crystal replacement, I was (very sheepishly, I might add) informed that I did not have the latest firmware which is needed to enable REFLOCK in the 2M module … This sounds (sadly) familiar and might be the issue … Grant NQ5T K3 #2091, KX3 #8342 > > If I set the Elecraft XG3 to 144.100 and feed its output into the > transverter input connector, the signal shows up at 144.095, 5 KHz low. > > > > I > CONFIG XV OFS is 144 -0.08 and cannot be changed, when I go to adjust it > REFLOCK appears. > > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
