Jim I have the same issue pre and post REFLOCK installation. My software is up to date.
I'm still trying to troubleshoot it. Joe W1GO > On May 3, 2016, at 14:03, Jim Spears <[email protected]> wrote: > > I have K3 s/n 6866 with internal 2m transverter. I have not paid much > attention to the transverter for a while but I noticed something odd a > couple days ago and have not been able to do anything about it. > > > > If I set the Elecraft XG3 to 144.100 and feed its output into the > transverter input connector, the signal shows up at 144.095, 5 KHz low. > > > > If I tell this K3 to output 2m rf on 144.100, I hear the signal at 144.015 > on K3 s/n 6425 which has an external 2m transverter. > > > > I first noticed this when monitoring a local 2m FM repeater and could not > copy its output until I tuned 5 KHz low. > > > > The K3 does have an external 10 MHz clock and CONFIG REF CAL has the > blinking asterisk. FWIW, the value shown is 49.379.962. > > > > CONFIG XV OFS is 144 -0.08 and cannot be changed, when I go to adjust it > REFLOCK appears. > > > > What's up Doc? > > > > Jim/N1NK > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
