Apologize if this question has already been asked/answered. I have K3s #106xx, so I need the mod.
Is there any downside to making the mod (other than risk). I mean, is there any chance of it affecting TX/RX quality, et al? Assuming not; just checking... 73, ______________________ Clay Autery, KY5G MONTAC Enterprises (318) 518-1389 On 6/29/2016 9:55 PM, Ron D'Eau Claire wrote: > Any K3S later than serial number 10787 (kit) or 10801 (factory assembled) > can power the K-Pod without further modification. The change was made on all > subsequent units. > > So I'd hazard the guess that yours is "ready to roll" without any further > issues. > > Yes, the K-Pod Owner's manual advises owners of older K3s or K3 rigs that > Elecraft will do the mod for them. > > Optionally, you can simply power the K-Pod from the 12 VDC power connector > on the back panel of the K3. A suitable power cable is included with the > K-Pod. > > 73, Ron AC7AC > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com