I have noticed one issue with my K-POD.
When I move the rocker switch to RIT/XIT on the K-POD and turn the
RIT/XIT function on from the front panel of my K3 spinning the knob on
the K-POD does not reliability change the value of the RIT/XIT. It will
tune some but not consistently. Turning the RIT/XIT control from the
front panel of the K3 works normally.
VFO A and VFO B respond to turning the knob on the K-POD normally.
With the rocker switch in XIT/RIT position on the K-POD and the K3
RIT/XIT function turned off then the K-POD tuning knob adjusts VFO A in
coarse mode. This is normal for the way I have the K3 programmed.
I assume this must be a bug in the 5.50 beta firmware which I have
installed.
As a side note installing the surface mount resister in the K3 is not
for those inexperienced in micro soldering.
Frank
K6FW
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com